Making Dog Stairs for Tall Beds
Dog stairs for tall beds – Dogs resting naturally in packs and usually welcome the opportunity to share a bed with their owners. Smaller, older or disabled dogs, however, may not be able to jump on or off a bed and can hurt themselves when trying. Try to bend down to lift a dog on a bed can cause back pain owner. A small staircase can help your dog get to bed safely and easily.
Make dog stairs for tall beds, cutting an 8-by-12 rectangle from the two side pieces, using a hand saw. Cut 12-inch sides of the 19¾-inch sides and the 8-inch sides of the 15-inch sides. Sand all the wood pieces to make them smooth. Mount the steps to verify that the pieces fit together well. Place the two sides, the long side down on a flat surface 30 inches apart. Place the stems in place of the two side pieces which are perpendicular to the ground. Place the steps in place of the two side pieces, parallel to the ground. Place the lid in place over the rear of the side panels. Highlight any irregularities, and saw or sand boards to correct the measurements if needed.
Dog stairs for tall beds, glue the board in place with wood glue and let it dry thoroughly. Mark the placement of the screws. When stair pieces fit together well, then drill 5/8 inch screw holes through these selections. Screw boards in place, with a screwdriver. Secure each riser and tread on the spot with three evenly spaced screws on each side. Attach the rear panel to the side panels with four evenly spaced screws on each side.