Make a Wall Mounted Wine Racks

0

Wall mounted wine racks – Wine Rack lend a sense of sophistication to the kitchen, dining and recreation areas. Most floor-mounted or countertop wine rack taking up valuable space that could be used for other purposes. A wall mounted wine rack adds aesthetics without taking up floor or counter space. Most homeowners can make and install a simple wall-mounted wine rack in the course of an afternoon.

How to make a wall mounted wine racks, cutting the board to a 4-inch width using a table saw. Sand the board easy to remove splinters and achieve an even surface. Round the edges of the long side and both short sides of the board with a router and a rounding bit. You can also use the router to round the corners. Select a line 1 ¼ inches from the rounded long side of the card and extending along the entire length of the board.

Related  Wrought Iron Wine Rack Tables

Mark and drill small holes for your mounts on the bottom of the wine rack. The holes should be slightly smaller than the diameter of the half-inch screws. The exact location of the brackets will depend on the width between your wall studs. If the studs are 16 inches apart on center, place each bracket 2 inches from one edge of the board. If your studs are 12 inches on center, place the holes so brackets are flush with the edges of the wine rack. Position and attach your attachments to the bottom of the wine rack. Place the wine rack so each bracket revolves around the stud. Mark and drill a hole in the wall for each console. Attach the wine rack to the wall with ½-inch wood screws. Insert wine bottles in the holes up and down. This wall mounted wine racks holds six bottles.

Related  Wood Wall Wine Rack
Share.

Comments are closed.