Easy Build Dog Stairs for Bed
Dog stairs for bed – Building portable step allows you to use them on bed, car and anywhere dog requires assistance. Portable steps are available through many pet stores, but building steps are relatively easy, and materials are cheap. Cut four 30-inch-long sections of foam insulation board with a utility knife. Then cut two 15-inch-long sections and set them aside. Boards in standard two foot width. Do not change width.
Place one of 30-inch foam sheet on ground. Use a soft brush to apply a thin layer of glue to top side of dog stairs for bed. Place a second matching table on top of glue. Adjust surfaces and apply gentle pressure to set glue. Wait five minutes for glue to dry. Repeat until all 30-inch boards are stacked and glued.
Place one of 15-inch boards on top of stack. Align edges on one side to cover half of surface. Use a marker to trace edge. Remove board and apply a thin layer of glue to area inside of mark. Place board on top of glue, align edges and wait five minutes for glue to dry. Apply a thin layer of glue to 15-inch board. Insert last 15-inch board on top, right edge and wait five minutes for glue to dry. Use utility knife to cut scrap carpet. Use coarse measurements to cover top of dog stairs for bed. Apply a thin layer of glue to stage and put blanket over glue.